StudentShare
Contact Us
Sign In / Sign Up for FREE
Search
Go to advanced search...

Specific heat capacity laboratory - Assignment Example

Cite this document
Summary
Determination of specific heat of certain materials can be carried out in a simple setting in which only heating and measuring temperature are the only tasks involved on the assumption that the value of the heat or energy used is derived from a power input typically in Watts or…
Download full paper File format: .doc, available for editing
GRAB THE BEST PAPER99% of users find it useful
Specific heat capacity laboratory
Read Text Preview

Extract of sample "Specific heat capacity laboratory"

Download file to see previous pages

substance by 1 degree which is obtained through the equation Q = m*C*∆T where ‘m’ refers to the mass of material, C is the specific heat and ∆T is the change of temperature. ∆T in Kelvins is the same in magnitude as ∆T in Celsius, hence, the specific heat for water may also be reported as 4.18 J/g-°C. Because the specific heat values for a given substance can vary slightly with temperature, the temperature is often precisely specified. (3) Record the initial temperature of water prior to heating.

Switch on the electric kettle and note down temperature reading measured after every 15 seconds until the instant is reached when the water starts boiling. The units for the special heat capacity based on C = Q / (m∆T) is J kg-1K-1 and by mere inspection, the rated power consumption of the kettle is 2200 Watts (or J·s-1). Thus, the maximum amount of energy that the kettle can be expected to transfer to the water over a period of 15 seconds is 33,000 Joules which is the product of power consumed and time elapsed.

Actual energy transfer may be less than this amount due to the energy lost through heating the kettle itself, the surrounding air, and even the noise which take up some dissipated heat in the process. Assuming complete energy transfer with a 100% efficient kettle, 2200*(t) = (200 grams)*(4.2 J g-1°C-1)*(100°C - 10°C) gives t = 34.36 seconds or the time it would take to get a 200-gram water to boil. The indicated form y = 0.462x + 27.34 translates to T = 0.462*t + 27.34. Clearly, the graph is a straight line, which plateaus at ~ 100 °C while the gradient remains constant (linear) with time until it reaches the boiling point.

Slope approaches zero or gradient flattens when the kettle is boiling. The gradient of this graph is the specific heat capacity of water 4610 J*kg-1K-1 or 4.61 J*g-1K-1(using the data points. Apparently, this makes an overestimate when compared to literature value of 4.2 J*g-1K-1 due to energy dissipation in the

...Download file to see next pages Read More
Cite this document
  • APA
  • MLA
  • CHICAGO
(“Specific heat capacity laboratory Assignment Example | Topics and Well Written Essays - 1000 words”, n.d.)
Specific heat capacity laboratory Assignment Example | Topics and Well Written Essays - 1000 words. Retrieved from https://studentshare.org/physics/1592546-specific-heat-capacity-laboratory
(Specific Heat Capacity Laboratory Assignment Example | Topics and Well Written Essays - 1000 Words)
Specific Heat Capacity Laboratory Assignment Example | Topics and Well Written Essays - 1000 Words. https://studentshare.org/physics/1592546-specific-heat-capacity-laboratory.
“Specific Heat Capacity Laboratory Assignment Example | Topics and Well Written Essays - 1000 Words”, n.d. https://studentshare.org/physics/1592546-specific-heat-capacity-laboratory.
  • Cited: 0 times

CHECK THESE SAMPLES OF Specific heat capacity laboratory

Aerobic capacity test

erobic capacity is measured in the laboratory using a graded exercise test during which the rate of oxygen uptake is measured continually using sophisticated equipment.... The Bruce Treadmill Test is one of the most popular laboratory treadmill test protocols used in obtaining VO2 max measurements.... Aerobic capacity is an essential part of physical fitness because it reflects the overall capacity of the cardiovascular and respiratory systems and the ability to carry out extended demanding exercise … Aerobic capacity is an essential part of physical fitness because it reflects the overall capacity of the cardiovascular and respiratory systems (Mitchell, Sproule, & Chapman, 1958; Taylor, Buskirk, & Henschel, 1955) and the ability to carry out extended demanding exercise (Astrand & Rodahl, 1986; Taylor et al, 1955)....
8 Pages (2000 words) Essay

Refrigeration Laboratory

This means that, this means the total energy input at the evaporator is the same as the total energy output at the evaporator. Results from the experiment were… ed under three main categories: heat pump heat capacity and coefficient of performance, compressor power before and after inverter and inverter loss versus the frequency of the compressor. It was noted the optimal intermediate temperature increased correspondingly with increase Additionally, high water inlet temperatures substantially affect R134a temperature....
8 Pages (2000 words) Lab Report

Determine Specific heat capacity of water and metals

To measure the specific heat capacity of these substances, which have a certain mass, an experiment is done.... The energy needed to increase one kilogramme of material by one kelvin or… The SI unit of specific heat capacity is J kg-1K-1 (International Bureau of Weights and Measures, 2006).... The specific heat capacity obtained for Water trial1 was (4076.... The specific heat capacity obtained for Aluminium was (890.... From the definition of heat capacity, the equation can be written as Q=m × c During the experiment, precautionary measures were observed in order to prevent accidents by adhering to laboratory rules and regulations....
7 Pages (1750 words) Essay

Heat of Solution for Various Salts

his experiment may be undertaken in the laboratory.... For this laboratory, an open system will be used.... This lab report "heat of Solution for Various Salts" sheds some light on the Ionic substances that are characterized by different changes in their structure.... hellip; Measuring heat changes using the above methods is not very accurate.... The heat produced is channeled to a known amount of water.... This is because when heat changes consider temperature differences....
6 Pages (1500 words) Lab Report

Refrigeration Laboratory

From the paper "Refrigeration laboratory" it is clear that the assumptions encompass steady pressure heat transfer across the underlying heat exchangers coupled with the reduction of the heat transfers to the environment because of the insinuated devices.... hellip; Comparing with the ideal VCRC, the data attained and computed from the laboratory slightly differ from the existing typical cycle (Whitman, Johnson & Tomczyk, 2005, pp.... A refrigeration cycle is a cycle that aids in the transfer of heat from the low-temperature sink to a relatively high temperature through the application of energy from the third source (Dincer & Kanoglu, 2013, pp....
6 Pages (1500 words) Lab Report

Isentropic Expansion of Ideal Gas

"Isentropic Expansion of Ideal Gas" paper determines a specific heat capacity of air at room temperature by allowing the air in a pressurized tank to expand adiabatically, during a quick opening action of a valve attached to the tank.... The value of the specific heat capacity of air could be calculated.... specific heat capacity is a quantity central to the thermodynamic analysis of a substance.... he specific heat (C) is critical because it determines how quickly a substance will heat up or cool down....
7 Pages (1750 words) Coursework

The Operations of the Cone Calorimeter by Using it to Quantitatively Analyze Various Samples

heat capacity can be quantified in terms of molar heat capacity which is the heat capacity of a particular compound divided by the number of moles of that compound.... Another quantitative aspect of heat capacity is specific heat which is the heat of an element divided by its mass.... It is also important to note that the heat capacity of any substance always has a positive value.... Cone calorimeter is an important laboratory device used to measure the characteristics of fire of small samples of various materials....
6 Pages (1500 words) Lab Report

Air-Air Heat Exchanger

… The paper "Air-Air heat Exchanger" is a delightful example of a term paper on engineering and construction.... The design ascertains how heat exchanger could be coordinated under various variations of its heating parameters to give a more reliable and controllable functioning of equipment.... The paper "Air-Air heat Exchanger" is a delightful example of a term paper on engineering and construction.... The design ascertains how heat exchanger could be coordinated under various variations of its heating parameters to give a more reliable and controllable functioning of equipment....
13 Pages (3250 words) Term Paper
sponsored ads
We use cookies to create the best experience for you. Keep on browsing if you are OK with that, or find out how to manage cookies.
Contact Us